No-Sew Paper Garland: Easy Project

Jump to Recipe Print Recipe

Learn how to turn a few scraps of paper and some twine into a no-sew paper garland that is perfect for any letter board!

Easy No Sew Paper Garland - The Kingston Home

I will put a garland on anything that isn’t nailed down. Including my Heidi Swapp letterboard and especially because these garlands are SO easy to make! Just a few scraps of paper and your Xyron Sticker Maker and you are ready to go! {FTC Disclaimer – this post contains affiliate links so I might make a few pennies if you buy something.}

SUPPLIES NEEDED:

xyron sticker maker and no sew paper garland supplies

patterned paper (I used the Lawn Fawn Perfectly Plaid Fall collection)
Xyron Sticker Maker
twine
trimmer
scissors

Do you want to order your Xyron products from amazon.com? Then check out my Adhesives & Fixatives page!

how to make easy no sew paper garland:

Trim paper to desired length and width (length should be about twice width). I wanted a tiny garland so cut the paper to 1.25 x 3. Fold each piece in half and then unfold. Cut twine to desired length.

Run each piece patterned side up through your Xyron Sticker Maker.

Peel paper from backing, place twine in the crease of the paper, and fold over. The paper will adhere to itself. Use your scissors to cut a notch in the paper to create a banner. Repeat until the garland is the desired length.

Even though I made this using fall paper, you could always make this same garland for different seasons and holidays! For instance, this project would be a great way to use up those small scraps that you may have after making holiday cards or certain types of scrapbook layouts.

All photos by Catrina Anne Photography.

Now, if you need some written instructions, then we have you covered! Check out the instructions box below to see all of the details for this project. Plus, you can even print them or pin them to your favorite Pinterest board!

Print This Pin This Rate This

Easy No Sew Paper Garland

Learn how to turn a few scraps of paper and some twine into a no-sew paper garland that is perfect for any letter board!

Author: Beth Kingston

Materials

patterned paper (I used the Lawn Fawn Perfectly Plaid Fall collection)
Xyron Sticker Maker
twine
trimmer
scissors

Instructions

Trim paper to desired length and width (length should be about twice width). I wanted a tiny garland so cut the paper to 1.25 x 3. Fold each piece in half and then unfold. Cut twine to desired length.
Run each piece patterned side up through your Xyron Sticker Maker.
Peel paper from backing, place twine in the crease of the paper, and fold over. The paper will adhere to itself. Use your scissors to cut a notch in the paper to create a banner. Repeat until the garland is the desired length.